SOPMagicSOPMagic

AI Forklift Training Video Generator

Generic forklift videos never match your trucks, your aisles or your checklist. Describe your procedure, and SOPMagic writes a step-by-step SOP and renders one short clip per step, so new operators see exactly what your site expects.

Generate my SOP

Shot-by-shot storyboard

Each SOP step becomes one short clip, with the step text shown alongside.

Sample: Forklift Pre-Use Inspection

  1. Step 1

    Park and secure the truck

    Park on level ground, lower the forks to the floor, set the parking brake and switch the truck off.

    Shot

    Wide shot of a forklift parked in a clear warehouse aisle, forks resting flat on the floor.

  2. Step 2

    Walk around and look for damage

    Check tires, forks, mast, chains and the overhead guard for cracks, bends, wear or loose parts.

    Shot

    Operator in a hi-vis vest walks slowly around the truck, crouching to look at a front tire.

  3. Step 3

    Check fluids and leaks

    Check fluid levels as the manufacturer specifies and look under the truck for drips or puddles.

    Never open a hot radiator or coolant cap. Let the engine cool first.

    Shot

    Close-up of a gloved hand pulling a dipstick, then a low angle under the truck showing a dry floor.

  4. Step 4

    Test the controls

    Seated with the seatbelt on, test the horn, lights, steering, service brake and parking brake.

    Shot

    Over-the-shoulder shot of the belted operator pressing the horn and turning the wheel.

  5. Step 5

    Test lift and tilt without a load

    Raise, lower and tilt the mast through its full range and listen for unusual noises or jerky movement.

    Shot

    The empty forks rise smoothly up the mast in an open aisle, then tilt back.

  6. Step 6

    Record and report

    Sign the inspection checklist. If anything failed, tag the truck out of service and tell your supervisor.

    Do not operate a truck that failed any check.

    Shot

    Operator signs a clipboard checklist beside the truck and hangs a red "out of service" tag on the steering wheel.

Always follow the truck manufacturer’s instructions and your employer’s procedures. This sample is illustrative and is not a substitute for operator training and evaluation.

Who it's for

  • Warehouse and distribution centers onboarding new operators
  • Safety managers refreshing daily inspection habits
  • Equipment dealers explaining checks on a specific model

Frequently asked questions

Does a forklift training video certify my operators?
No. OSHA requires formal instruction, practical training and an evaluation of each operator’s performance in the workplace. A video made with SOPMagic is a teaching aid for the formal-instruction part, not a certification.
Can I use my own checklist and truck model?
Yes. Paste your checklist or describe your truck in the details box. The SOP follows what you provide, and each step becomes its own clip.
How long is the finished video?
Each step is a short clip of about 5 to 10 seconds, so a six-step inspection runs well under a minute, with the step text shown next to each clip.
Do I need an account to try it?
No. Writing the SOP is free and needs no sign-up. You only sign in when you turn the SOP into video clips.

Make this video for your site

Start from this procedure, add your own equipment and rules, and get your SOP free in seconds.

Generate my SOP

More training videos